Pugmill adaptor

pug adaptors x3.jpg
pug adaptors x3.jpg

Pugmill adaptor

from 279.00

This is our pug mill adaptor it can be easily adjusted to fit your pugmill.

 

SIZE:
Quantity:
Add To Cart
pug adaptors x3.jpg

Our  pugmill adapter are designed to make it easy to refill our polycarbonate tubes. This adapters fit most common pugmilld and we can provide custom adapters.


We have 3 primary types of adapters. The most common is the 2000 ml adapter with 7 inch round plate undrilled. This plate is ideal for a variety of pugmills, after you receive the pugmill adapter you will have to drill holes to match your flange holes. Some pugmills like this mall Venco have a substantial flange but typically have no holes so in this case it's necessary to drill and tap for fasteners. Typically four or five M6 or M5 Fasteners are sufficient.

The second pugmill adapter is for the 3600 5500 again just with a circular plate for adapting on to various pugmills.

The third  pug mill adapter  is a little more complicated and requires substantially more Machining. These adapters are for the larger pugmills like the Peter pugger VPM60 and similar pugmills.
It's become a little difficult with all the different hole patterns so the best results are achieved if you provide us with a simple  pattern of the holes or  even what we call a rubbing of the holes. This can be easily accomplished by placing clean paper over the flange and using the edge of a pencil and gently finding the inside and outside parameters along with the holes. This way we can match up your pugmill hole pattern.

Untitled-1.jpg